Need to configure ephone mac address5/31/2023 This command sets the maximum number of dialing numbers (extensions) that CME will allow. If more phones were required, you could manually issue the command with however many phones you need. During the initial setup, only 2 were indicated. This command sets the maximum number of physical phones that are allowed to connect to CME. This way you can specify specific firmware for different models if needed. In this case, its for the 79 series of phones. This command identifies the firmware to load for specific phone models. The following configuration is a bare bones example of the telephony-service section: The actual telephony commands are scattered through-out the running configuration and are not limited to the telephony-service section. The IP phone configuration starts in the telephony-service section of the running configuration. It is important that you familiarize yourself with the command line configuration as CME lives half in the GUI and the other half in the command line. They are located in the telephony-service section. On your router, examine your running config to see the telephony changes added.
0 Comments
Leave a Reply. |